Blow Back Rig

Step 1. Using a Gardner Stripper tool peel back several inches of braid.

Step 2. Cut off the tag end.

Step 3. Tie on a Covert Ring Ring using an overhand knot.

Step 4. Attached a size 8 Covert Mugga hook using knotless knot with the rig ring in this position.

Step 5. Tie a figure of eight loop knot.

Step 6. Add a mouse dropping size of Critcal Mass Putty where the hinge starts.

Step 7. Cut off a cylinder of Gardner Zig Rig foam into two pieces as shown.

Step 8. Mount the disk of foam as shown.

Step 9. The finished rig.