What you

What you’ll need…

Step 1. Start off by stripping off 12-15cm of your favourite skinned hooklink.

Step 1. Using a Peel and Pull stripper tool remove around 3 inches of coating.

Step 2. Tie a small loop in the end to retain the hair stop when the rig is finished.

Step 2. Tie a small loop in the end to retain the hair stop when the rig is finished.

Step 3. Tie a small loop in the end.

Step 3. Tie a small loop in the end.

Step 4. Here

Step 4. Here’s the trickiest bit – thread the rig ring on the hook and secure with a knotless knot.

Step 5. Thread an 8mm section of 0.5mm tube down the hooklink.

Step 5. Thread an 8mm section of 0.5mm tube down the hooklink.

Step 6. Push the tubing up over the eye of the hook so 2 or 3 mm are below the hooks eye...

Step 6. Push the tubing up over the eye of the hook, so 2 or 3mm are below the hooks eye…

Step 7. Your hook should hopefully now look a little like this!

Step 7. Your hook should hopefully now look a little like this!

Step 8. Create a hinge at the height you ant to fish the pop up by stripping a small section of hooklink.

Step 8. Create a hinge at the height you ant to fish the pop up by stripping a small section of hooklink.

Step 9. Mould some Critical Mass for the pop up counterweight on the hooklink just above the stripped section as shown.

Step 9. Mould some Critical Mass for the pop up counterweight on the hooklink just above the stripped section as shown.

The finished rig.

The finished rig.